Payment Type:L/C,T/T
Incoterm:FOB,CFR,CIF,EXW
Min. Order:500 Kilogram
Transportation:Ocean,Land,Air,Express
$4.5≥500Kilogram
Model No.: High Tensile Strength cold drawn stainless steel wire
Transportation: Ocean,Land,Air,Express
Payment Type: L/C,T/T
Incoterm: FOB,CFR,CIF,EXW
Annealing Stainless Steel Wire is a heat treatment process used to soften materials and improve their properties. For cold drawn Stainless Steel Wire, it is usually annealed to eliminate internal stress and increase ductility.
SUS 316 cold drawn stainless steel wire annealing can be carried out according to the following steps:
1. Clean the wires: Use a suitable solvent or cleaner to remove dirt, oil, or other contaminants from the surface of the wires.
2. Preheating furnace: Preheat the annealing furnace to the required temperature. The recommended annealing temperature for SUS 316 stainless steel is typically 1010°C to 1120°C (1850°F to 2050°F).
3. Place the wire rods into the furnace: Carefully place the cold-drawn stainless steel wire rods into the annealing furnace, making sure they are evenly spaced and not touching any other objects.
4. Heating metal wire: Stainless Steel Soft Annealed Wire allows the metal wire to heat up slowly and evenly in the furnace. This can be accomplished by gradually increasing the temperature over a period of time, usually at a rate of 50°C to 100°C (90°F to 180°F) per hour.
5. Maintain annealing temperature: Once the desired annealing temperature is reached, maintain it for sufficient time to allow the material to fully anneal. The recommended hold time is usually around 1 to 2 hours.
6. Cooling: After the Soft Coil Stainless Steel Wire annealing process is completed, gradually cool the wire to room temperature. This can be done by turning off the furnace and allowing it to cool naturally or using a controlled cooling process.
7. Inspect and test: After the wires have cooled, inspect them for any signs of discoloration, deformation, or other defects. In addition, perform any required mechanical or chemical testing to verify that the required properties have been achieved.
It is important to note that the specific annealing process may vary depending on the specific requirements of the stainless steel wire and the equipment available. It is recommended to consult a material supplier or metallurgical expert for guidance on the best annealing process for SUS 316 cold drawn stainless steel wire.
Product Name | AISI/ASTM/SUS 304 316 Annealing High Tensile Strength cold drawn stainless steel wire |
Surface | soap coated and bright |
Standard | ASTM A580, JIS G4309, EN 10088-3, GB/T4240 and Other Equivalents |
Grade | 201, 202, 301, 302, 304, 304L, 304H, 304N, 316L, 321, 410, 420, 430 |
Temper | Annealed and Soft, 1/2 hard, 3/4 hard and full hard conditions |
Diameter | 0.6-6.0mm |
Type | Stainless Steel Spring Wire/ EPQ wire, Cold heading wire, Stainless Flat steel wire |
Packing | Spool or roll |
Used | industrial,medical,life field, kitchen usage |
Product Details
Packing & Delivery